BIOS 刷黑后 用软驱恢复（国外英文资料）.doc

BIOS 刷黑后 用软驱恢复（国外英文资料） An AWARD USES the BOOT startup area to restore the analysis of the BIOS The BIOS repairs website mouse production Note: this article is copyrighted by the BIOS website. Please do not reprint it or use it for other business purposes. Updating the BIOS, you can solve problems such as hardware compatibility or big hard drives, so users will upgrade their BIOS to the latest version as much as possible. But when we refresh the BIOS, we can use Boot Block to restore the BIOS, as the refresh process stops or the BIOS file writes errors. The Boot Block is the Boot Block, the Boot Block, which is a piece of a block-style BIOS structure that keeps an area in the BIOS chip, which holds the most important startup information in the BIOS system. The default value for a high version of the refresh program now is to refresh the Boot Block of the BIOS without updating the BIOS (figure 1). As the BIOS version is different, also with its BOOT support for drive, in the previous old motherboard, if the BIOS is damaged, it is not any display BOOT, but floppy drive with loading action, at this time we can use the automatic batch or install ISA graphics methods to enter the recovery (at this point, the BOOT only supports the floppy drive and ISA CARDS); Second, with the update of the BIOS version and the popularity of the AGP graphics card, BOOT supports AGP graphics and floppy drives (when the BIOS is damaged, the screen is displayed, as shown in figure 2); 3 it is, as a result of use floppy not much now, for the convenience of repair, the BOOT to support the hard disk, can recover from the hard disk (after the BOOT, the screen display, prompt to recover from a hard disk, as shown in figure 3) Figure 2 FIG. 3 When the BIOS refresh fails, we can use the floppy disk and the hard disk to recover from the prompt. But there is a problem, we used approach is to create a startup disk, and then make autoexec. Bat batch file, use the floppy disk to go up and the BIOS file