科蒂斯交流电机控制器参数表（国外英文资料）.docVIP

科蒂斯交流电机控制器参数表（国外英文资料） Curtis ac motor controller parameter table Programming parameter With the CURTIS 1311 handheld programmer or the 1314 programming station, the controller can be configured for this purpose. These parameter Settings enable the customer to customize the performance of the vehicle to meet the user specific application requirements. For an operation of the programmer, refer to the attached table C. menu The programming parameters are categorized and shown in the menu by the level, as shown in table 3. The telephone should be tuned The characteristic adjustment of the motor response can be achieved by speed control or torque control. It depends on specific application needs. The CURTIS controller provides the following adjustment mode: Simplified version speed pattern Speed mode Torque mode The simplified version of the speed pattern reduces the Settings of some parameters, making it easier for users to adjust and adapt to most application requirements. The speed model, including the simplified version of the speed model, applies to the application of the accelerator input control motor speed output. The torque pattern is applied to the application of the input control motor torque output. Note: torque control and speed control are not available at the same time. For example, if you have the speed or simplified model, and then you go to adjust the torque control parameters, the parameters of the new adjustment will not produce effect. Refer to the following list of parameters. CURTIS INSTRUMENTS (CHINA) CO., LTD. The CONTROL MODE SELECT... P27 0. SPEED MODE EXPRESS... were Max Speed... .. Maximum speed Kp proportional control Ki integral control Accel Rate accelerates the adjustment Decel Rate decelerated Brake Rate Brake adjustment Pump Enable Pump can make 1. The SPEED MODE MENU Speed Controller Max Speed Max Speed Kp speed proportional control Ki speed integration (setting speed versus actual velocity) Vel Feedforward speed forward Kvff low spee