抹光机英文说明书.docVIP

OPERATING INSTRUCTIONS Power Trowel HGM60 WARNING ! To reduce the risk of injury, all operators and maintenance personnel must read and understand these instructions, before operating, changing accessories, or performing maintenance on our equipment. All possible situations can not be covered in these instructions. Care must be exercised by everyone using, maintaining or working near this equipment. I. Application The high-efficient, easily-operated combustion trowel, are used to floating and polishing the surface of concrete with ideal effect. Floating weight, speed choice of blades and the height control handhold can produce the excellent high output. II. Warning 1. To be safe, Notice must be set up on the spot to keep non-expert (especially for kids) from the working area 2 meters at least. In case of happening, the machine must be shut down at once. 2. Operating the trowel with level or keeping angle of inclination less then 20 degrees to stop oil running over from tank so as to it could work well. 3. Not to be injured, when it is working, please do not step on the protection cover of trowel. 4. When starting, operator must keep controlling with a safe working distance. 5. Please wear the special shoes to protect yourself when working. 6. Adding oil in airiness place and screwing down the cover tightly after finishing. Please check if the tank is leaked each time, if did, please do not start it before repairing. 7. No adding oil when engine is little hot even or it is running. Keeping oil clean and making sure oil is not too full otherwise it would be run over and jam carburetor, once oil run over please clean it before starting. III. Inspection before starting Check the engine lubricating oil Screw the oil scale and clean the oil on the oil scale. Th