预制混凝土板块和水泥方砖路面铺设施工工艺标准(国外英文资料).docVIP

预制混凝土板块和水泥方砖路面铺设施工工艺标准(国外英文资料) According to the standard Uniform standards for quality acceptance of construction projects gb50300-2001 Construction quality acceptance and acceptance criterion gb50209-2002 1, scope, This process is suitable for industrial and civil construction site, courtyard road and parking lot, laying precast concrete slab and cement tiles. 2, construction preparation, Materials and main tools: Precast concrete plate: the strength should not be less than 20MPa, the specification is 49.5 cm x 49.5 cm, the pavement thickness is 10cm, and the pavement and yard block thickness is 5cm above. In the approach, there should be a record of factory certificate and concrete strength test. The surface of the concrete plate is inspected, the surface of the surface is solid, without the surface, the crack and the peeling, the corner square is positive, no distortion, lack of Angle, falling edge. The plate allows deviation: long, wide, plus or minus 2.5 mm, the thickness is plus or minus 2.5mm, the length is greater than the 400mm and the LMM, the length is greater than the 800mm, the flatness is 2mm. 2.1.2 cement square brick: size is 25 cm x 25 cm x 5 cm, compressive strength, flexural strength, comply with the design requirements, the specifications, variety selection according to design requirements, the appearance of edge tidy founder, surface smooth, level off, without distortion, missing Angle, edge phenomenon, comes into play have factory certification. Sand: coarse sand, middle sand. 2.1.4 cement: no. 325 or more ordinary silicate cement or slag silicate cement with factory certificate. Grind lime powder: 48h before use. Prefabricate concrete and floss, prefabrication according to drawing dimension and strength level. 2.1.7 major equipment: small, half barrels, broom, bucket flat shovel, iron float, big wooden poles, small wood, wire netting, sieve, sieve, watering can, hammer, rubber hammer, chisel, and of the valve plate fixture, pole, trolleys, et