高级分区技巧(国外英文资料).docVIP

高级分区技巧(国外英文资料) The new hard disk cannot boot the system until it is partitioned and formatted. We can boot the system through bootable CDs (such as Win98/Me boot disks) or floppy disks with boot functions. If your system does not support this startup mode, then enter the BIOS setup program, First Boot Device (first boot device) is amended as ATAPI CD-ROM Drive (CD-ROM Guide) or Floppy Devices (floppy). Use the Fdisk command to partition with CD or floppy disk boot system after entering DOS state, run the command Fdisk, the screen will appear a English message, the last line Do you wish to enable large disksupport (y/n)? asks the user if they want to use a large hard disk mode, this need to type Y otherwise, cannot create more than 2GB capacity hard disk partition. After running Fdisk, the system asks if you want to use the big hard disk mode, and then you must select Y, otherwise you will not be able to create more than 2GB of hard disk. Create Primary DOS partition Next, go to the Fdisk main interface, where there are four options, with the following meanings: Create, DOS, partition, or, logical, DOS, drive: create DOS partitions and logical drives Set active partition: setting active partitions Delete, partition, or, logical, DOS, drive: delete partition or logical drive Display partition information: displays partition information Creating DOS partitions in Fdisk. If this is a new no hard disk partition, select the 1 press enter, will see a new window, select the 1. Create Primary DOS partition, to create a primary DOS partition, the Fdisk program will ask Do you wish to use the Maximum available size for a Primary DOS Partition (Y/N) the default is Y, this will be all the hard disk space to create a partition, recommended to choose N to create multiple partitions on the disk, or poor management, also easy to cause the waste of hard drive space. Before you create the primary DOS partition, the system asks if you want to create all of your disk space into a parti