电脑散热(国外英文资料).doc

电脑散热(国外英文资料) CPU hardware cooling method The heat dissipation method is all about money, and the drama of free hardware cooling is two things: decontamination and adding grease. By using these two simple and effective free methods, you can also achieve the cooling of the CPU. The CPU radiator is mainly composed of radiator and cooling fan. Normally the cooling fan in the case is cooled while inhaling dust, which is the enemy of electronic devices. Dust accumulation on the surface of the CPU can cause short circuit failures and even burn down. In addition, too much dust will also obstructed the gap between heat sink and the CPU fan bearings, obstruct the ventilation and heat dissipation, noise increase, reduce the heat dissipation effect, and eventually lead to damage to the CPU fan strike, so through the radiator dust decontamination, add oil fatliquoring, to improve and restore the performance of the radiator. Tool post There is a way of doing it: the work is done to the good, but the first. Need to be prepared before cleaning weapon includes: cross screwdriver, soft scrub brush or waste toothbrush, degreased cotton swabs and toothpicks, lubricating oil, thermal paste, alcohol, and a basin of warm water with a neutral detergent, etc. (as shown in figure 1). Remove the radiator from the cleaning tool Which cross screwdriver to open the case, soft brush to remove the dust on the surface of the radiator, degreased cotton swabs, toothpicks with alcohol to clean the cooling fan and radiator, fan, groove details, such as lubricating oil and thermal paste is used to fan motor respectively, CPU and other components to add, a basin of warm water is available with a neutral detergent to soak cleaning heat sink, buckle etc. Neutral cleaner can be replaced by regular detergent. Practical article Dust the dust When the necessary tools are in place, clean work can begin, and be sure to turn off the power supply and then pull down the power cord and all external connections. Fir