岗位职责及章制度.doc

企业各项规章制度（草稿） 副总经理的岗位职责：做好的工作计划和经营计划的实施工作。??? 、代表公司参加重大的内外活动；、审核公司名义发布的各种文件；、领导制定公司的市场运营、发展战略及规划；、领导制定公司年度计划，中长期发展计划等；、批准公司的年度财务预算；、领导公司建立各级组织机构，并按公司战略规划进行机构调整；、领导公司制定各种规章制度，并深入贯彻实施；、决定各职能部门主管的任免、报酬、奖惩；、加强企业文化建设，搞好社会公共关系，树立公司良好的社会形象；11、定期主持召开员工座谈会，了解员工动向；12、定期组持召开公司质量分析会对公司的增收节支工作负责，做好公司的各项创收增效工作。14、完成交办的其他工作任务。 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring support