通用注射模具设计步骤(国外英语资料).docVIP

通用注射模具设计步骤(国外英语资料) The general design of the injection mould for step.Txt the happiest in the world of fairy tales, but spent fuel for years. One is willing to wait, the other is willing to appear. Feelings sometimes just a persons matter, and no one has nothing to do. Love, or not love, can only do it by itself. Design procedure of universal injection mold Preparation before design The designer of the mould should design the mold on the basis of the design task book, and the design task of the mould is usually put forward by the plastic products production department, The task book contains the following: (1) after the formal plastic drawings signed by the contract, and indicate the plastic grades and transparency used, if the drawing of the plastic parts is based on the sample test It is better to attach samples, because the samples are more vivid and visual than the drawings, and can be of great value to the mould designers Information such as gate location, ejection position, parting surface, etc. used in the sample. (2) plastic parts, specifications and technical requirements. (3) the quantity of plastic parts produced and the injection machines used. (4) the basic structure, delivery date and price of the injection mould. Before the mold design, designers should pay attention to the following points: 1. familiar with plastic parts (1) familiar with the geometry of plastic parts For samples of complex plastic parts drawings, with the aid of hand drawing axonometric or computer modeling method, the establishment of clear plastic parts in the mind Three dimensional images, and even a model of the material made of clay and other materials to familiarize them with the geometry of the plastic parts. (2) make sure the requirement of plastic parts After the geometry of the plastic parts is completely familiar, the use of the plastic parts and the function of each part are also of great importance. Should pay close attention to plastic Requirements for the use of plast