复印机 故障代码的复位方法集合(国外英语资料).doc

复印机 故障代码的复位方法集合 Method for resetting the fault code of a copier First, Li Guang (Ricoh) copiers Special fault code Ricoh copier includes a heat roller fuser fault code and exposure lamp fault code. Wherein, the hot roller fuser fault is expressed as code E5X or E54X, and the exposure lamp fault is expressed in the code E101. Ricoh FT4215, FT4220, FT4222, FT4418, FT4422, FT4495 copier fuser hot roller fault code E52, E53, E55 according to the following method of reduction: 1) copier master switch OFF, remove the back cover of the copier. Copier master switch ON; 2) copier on the main control panel DIPSW (Dual In line Package Switches dual in-line switch group) 101 / 1 ON/O FF; 3) copy machine master switch OFF, mount the back cover of the copier. Copier master switch ON. Ricoh FT4027, FT4127, FT4527, FT5035, FT5135, FT5535, E101 and E541 special copier fault code to E544, E547, E548 according to the following method of reduction: 1) copier master switch ON; 2) sequentially press the energy / mode clear key, the numeric keys 1, 0, 7, and the clear / stop key. Note that the key operation should be completed within 20s, and finally press hold / stop button to keep 3S above; 3) enter 5 with numeric keys, press read / enter keys, enter 810 with numeric keys, press read / enter keys; 4) copier master switch OFF/ON. Two, SHARP (SHARP) copiers SHARP copier special fault code includes hot roller fuser fault code HX, master board battery voltage low, fault code U1 and memory read write fault code U2. SHARP SF1016, SF1020, SF1025, SF1116, SF2014, SF2020, SF2022, SF2027, SF204, SF2114, SF2214 0 copier fuser hot roller fault code H2, H3, H4 said, with directive 14 reduction; memory read and write fault code U2, with 16 reset instruction. SHARP SF7320, SF7370, SF7700, SF7750, SF7800, SF7850, SF8570, SF8870 and other hot roll copier fuser fault code H3, H4 said, with directive 14 reduction; the main control board with low battery voltage fault code U1, with 13 reset instruction. Th