大口径结构壁管环刚度试验机测力系统的应用研究_牛君.pdf

DOI:10.15925/j.cnki.issn1005-3360.2012.10.001 加工与应用 Vol.40 No.10 (Sum.246) October 2012 文章编号： （ ） 1005-3360 2012 10-0058-04 大口径结构壁管环刚度试验机测力系统的应用研究 Study on Load Measurement System of Ringstiffness Tester for Large Diameter Structral Wall Pipes 牛君 Niu Jun - 石家庄职业技术学院，河北石家庄 050081 - Shijiazhuang Vocation and Technology Institute, Shijiazhuang 050081, China 摘　要 : 分析了大口径结构壁管环刚度测定中，试样结构壁的不均匀性及侧偏放置对测量结果的影响，提出了三点测 力传感器结构的测力系统方案，并以此为基础给出了该方案的硬件结构和软件设计，进而同单点测力传感器 测力系统进行了试验对比。结果表明：三点测力传感器结构测力系统，可以有效地消除因试样结构壁不均匀 及试样侧偏放置而造成的环刚度测定误差。 Abstract : According to the influence analysis of non-uniform structural wall and off-central placement on ringstiffness testing for large diameter structral wall pipes, a load measurement system with three-load sensor structure was proposed. On this base, the structures of hardware and design of software was presented, and experimental comparison of load measurement systems between three-load sensor structure and single load sensor structure was also made. The results show that the measurement error of ringstiffness caused by non-uniform structural wall and off-central placement is effectively eliminated by applicaton of load measurement system with three-load sensor structure. 关键词 : 环刚度；测力系统；三测力传感器；单测力传感器 中图分类号 : TQ320.55 文献标识码 : A Key words : Ringsti