操纵路由选择更新(国外英语资料).docVIP

操纵路由选择更新(国外英语资料) First, migrate to multiple IP routing protocols Reason: change the routing update a variety of reasons, 1. As the network scale is increasing, more and more complex, the original routing protocol is no longer the best routing protocol. 2. The network is currently used CISCO IGRP and EIGRP, now need a support for many manufacturers equipment agreement, or a new strategy requires the introduction of a specific routing protocol. Sometimes, running multiple routing protocols is part of network design, not part of the migration process. Mode: do gradual migration - migrate different site points each weekend, or migrate to a new address space at once. The EIGRP and OSPF use the main interface address: these two protocols use the main IP address of the interface as their source of updates. They expect the routers on both ends of the link to belong to the same subnet. The EIGRP and OSPF do not accept updates from routers in other subnets and do not establish adjacency relationships with routers in other subnets; In this case, the EIGRP will continue to generate error messages. Therefore, an adjacent router must be assigned the primary IP address of the same subnet. The routers auxiliary address and the host IP address of the adjacent router do not need to be in the same subnet. Second, redistribute the overview In some cases, the same protocol may be used for different domains of the network (autonomic systems), and multiple instances of the same protocol are considered different protocols; To exchange routing information between them, you need to redistribute. The routing must be in the routing selection table to be redistributed. When not in use redistribute, router perform nightly run (ships - in - the - night, SIN) routing: interface using the participation OSPF routers pass OSPF routing updates to OSPF neighbors, use in EIGRP interface will be passed to the EIGRP routing table updates EIGRP neighbor. Router A does not exchange route selection informat