楼层位移比”的定义(国外英语资料).docVIP

楼层位移比”的定义(国外英语资料) Floor displacement ratio : the definition of the maximum elastic floor horizontal displacement or displacement between layers and elastic horizontal displacement on both ends of the floor (or interlayer displacement) the ratio of average. Purpose is to limit the structure of the torsion value, and its structure of reverse translation cycle than with belong to the concept of control structure reverse aspect, and reverse translation cycles than mainly inspects the structure of the ability to resist torsion, torsion cycle is too large, show that the structure is weak torsional. Calculation of the floor displacement ratio requirements: the provision which illustrate 3.4.2, rules, rule 3.4.3 pointed out that, to reverse the irregular, calculated on the rigid floor slab, when the ratio of maximum displacement between layers and its average of 1.2, is equal to the end of 1.0, the other end is 1.45; When the ratio is 1.5, the equivalent is 1.0, and the other side is 3. This shows the displacement of floor than should be calculated under the condition of rigid floor assumption, namely considering floor slab in the in-plane stiffness of infinity, there is no relative displacement between point and point of floor, floor as a rigid body in the floor plan with horizontal displacement and rotation. The other high gauge stipulates that the displacement ratio of the calculation floor must be considered by the accidental eccentricity of the mass. The concept of mass accidental partiality Structural calculation should be considered when due to construction, use, or torsion component of earthquake ground motion caused by the factors such as the quality of the adverse impact of accidental eccentricity, so the article 3.3.3: rules, should be considered when calculating the one-way seismic action effect of accidental eccentricity. 3.3.3 according to specification formula, directly take the layers of quality accident eccentric 0.05 Li (Li is perpendicular to the directi