自校准流程(国外英语资料).docVIP

自校准流程(国外英语资料) 1: if you need to fix the system module that was damaged during the SelfTest run; 2: execute the formatting commands of p-list and g-list; 3: run the logical scan and check the hard drive; This time you should pay attention to, I repair some cases SelfTest is completed with a mistake, drive system to module may be damaged, therefore, should consider to track data backup system information. It is worth noting that the SelfTest will lose all the user area data, which means that after the SelfTest the hard drive has no data and all of it is erased. The repair of wdEB40 wholesale SSSSSSSSS Jump the main disk into 3000, wait for the parameter to return enter the main interface. Execute 1-1-1, check for a moment, you will see errors in the negative channel area, dont exit F2, write firmware, exit, and do disk regeneration. Without electricity, its all good to turn on the MHDD. ERASE most times. It didnt take long for me to meet you again! In these days, I didnt have time to fix the MT330 hard drive I didnt get before. Let me talk about the experience of working hard drives these days. I hope I can communicate with each other. Thank you! A friend of mine, a few days ago that I can repair the hard disk of the underlying fault, that day he came to me, call I have time to look at you, listen to his accent, seemingly this hard drive is a little loathe to give up, I hear in the ear, want to in my heart! Say yes to him, and do it for him! In the spirit of yesterday, I was happy to fix it. Looking at the phenomenon, the 330 disk was identified as the code for the model plus the circuit board! Plate, like this idea is: safe mode, 3 k plus LDR, RAM, check the G, P table to see if there is any error, empty P table again, if not empty, are literally add a record to the table, P power to restart again and again into the 3 k to empty, if it cant solve; Reset four modules (pay attention to when reset, be sure to backup LDR, firmware, or reset error, can damage module, ther