CAD快捷键自改过(国外英文资料).docVIP

CAD快捷键自改过(国外英文资料) Lesson 1: relevant concepts of AUTOCAD Straight line: L (press C to close the line, press tab to switch the angle) Tectonic line: Xl (H V A according to the level of vertical angle, select object can select from left to right, some only from right to left, the XL structure of the money can only be from right to left to check.) Polyline: pl (and straight line) is the whole and part of the line. Change the arc, press A (100) to the straight line, press L. According to the specified width W nock (10) starting point and end point arrow width with W (50) W (0). Multi line arrow with dimensions - starting point 30, terminal 30/A300/L200/w, 60, ending 0) Regular polygon: pol Rec (0-420-297: rectangular painting creased three points; C10-500-100 chamfer fillet; the first began to change back to 0 chamfer value 10 F10-100-100) Second lesson: AUTOCAD tools introduced First, select three commonly used methods: 1) drag the window from left to right and select the box to select; 2) drag the window to the right and left, and select as long as you are exposed to the object. 3) pick Two, mouse operation: 1) the middle key rolls outward to enlarge the window, and then rolls inside to reduce the window 2) press the middle button two times, equal to the window all show 3) press and hold the middle button to move the window 4) press the right button to correspond to the keyboard return key Three 、 drawing tools 1) straight line (L): you can draw a straight line by specifying two points on the screen 2) rectangle (REC) 3) arc (ARC) 4) circle (C) 5) line: for mark (not important) 6) spline curve: (SPL) with the left key to determine the points after the three return, the first break, the starting point of the second tangent direction, the third end tangent direction. 7) ellipse (EL): not commonly used, first give the long axis of the long axis, and then give the half of the short axis, or to central painting, the length of each axis to half 8) elliptical arc: not common