一种采用无源辅助网络的零电压三电平变换器.pdfVIP

2007 年 10 月 电工技术学报 Vo1.22 No. lO 第 22 卷第 10 期 TRANSACTlONS OF CHINA ELECTROTECHNICAL SOCIETY OCI. 2007 一种采用无源辅助网络的零电压 三电平变换器 孙铁成付雷王宏佳梁联朱雪秦 (哈尔滨工业大学电气工程及自动化学院 150∞1 ) 摘要 针对典型的 ZVS 复合式全桥三电平变换器存在滞后桥臂实现零电压负载范围率、变压 器二次电压过冲大的缺点，提出了一种采用无源辅助网络的改进型拓扑.该拓扑在电路中加入电 流增强网络及电压钳位网络，有效地拓宽了滞后桥臂实现零电压开关范围及抑制了变压器二次电 压过冲.详细地分析了该拓扑的基本工作原理，零电压实现的条件以及辅助网络参数的计算，并 制作了一台 12V/l OA 的实验样机.实验结果证明了理论分析的正确性及改进拓扑的可行性. 关键i司 z 三电平变换器 零电压开关 辅助网络 中圈分类号: TM46 Zero-Vo Itage-Switching Three-Level Converter Using Passive Auxiliary Net Sun 1íecheng Fu Le i Wang Hongjia Liang Lian Zhu Xueqin (H盯bio Institute ofTechnology Harbio 150001 Chioa) Abslracl The cooventional ZVS hybrid full-bridge three-level converter has several drawbacks , such as narrow ZVS load range of laggiog bridge and voltage spike of the transfonner secondary side. In order to overlωme these drawbacks , an improved ZVS three-Ievel converter using passive auxiliary net is proposed in 由is paper. A cuπent enhanced circuit and a voltage clamping net are introduced 阳 wider the load range of lagging bridge and reduce the voltage spike of the transfo口n町 secondary side. The operation modes of the improved topology, the conditions of ZVS and the calculation of 由e par田neters in auxiliary net are analyzed in detail. The correctness of the theoretical analysis and the feasibility of the improved topology are verified 00 a prototype converter of 12V11OA. Keywords. Three-Ievel converter, zero-voltage-switching , auxiliary net 压定额.但高耐压值 MOSFET 的导通电阻 R.μn) 1 号|言 较大，导致通态损耗增大，不利于变换器效率的提