钢精算量(国外英文).docVIP

钢精算量(国外英文资料) Basic method of reinforcement calculation Chapter I beam Section 1 frame beam First, the calculation of steel reinforcement 1, the upper through tendons The upper perforated rebar (rib 1 = length on long) through cross span long + two end bearing anchor value 2, end support negative ribs The negative length of end support: the first row is the anchor value of Ln/3 + end support; The second row is Ln/4 end support anchor value 3, lower reinforcement The reinforcement length = span long + about bearing anchor value Note: the result of the calculation is the same for the lower reinforcement, no matter whether it is divided into rows or not, so we can not input the line information when we mark the lower part of the beam and the longitudinal reinforcement. The above three types of steel are involved in the bearing anchor problem, then, in the software, how to achieve the 03G101-1 in the bearing anchor judgment? Now lets sum up the judgment of anchor support for the three types of steel bars: Bearing width is greater than or equal to Lae and 0.5Hc + 5D, Max{Lae, 0.5Hc + straight anchor, 5D}. The anchor end bearing steel bar = bearing width less than Lae or less than 0.5Hc + 5D, Max{Lae bending anchor, bearing width - protective layer +15d}. The middle bearing anchor bar = Max{Lae, 0.5Hc5d} 4, lumbar tendon Structure: reinforced structural reinforcement length = span length + 2 * 15d Torsion bars: algorithm with through bars 5, pull the tendons Tensile length = (Liang Kuan 2 * protective layer) + 2 * 11.9d (seismic bending hook value) + 2D Brace root number: if we do not have in the flat cloth reinforcement spacing input method given in the stretch, then stretch the root number (root number /2 = stirrup) * (structural reinforcement root number /2); if the reinforcement reinforcement spacing, reinforcement that root number = length / reinforcement reinforcement spacing. 6, stirrups Stirrup length = (Liang Kuan - 2 * protective layer + beam height -2 * protecti