基于绕组复变换的双三相异步电动机建模研究.pdfVIP

第 23 卷第 6 期 系统仿真学报© Vol. 23 No. 6 2011 年 6 月 Journal of System Simulation Jun., 2011 基于绕组复变换的双三相异步电动机建模研究 王步来，黄 磊，顾 伟, 吴卫民 (上海海事大学电气自动化系，上海 200135) 摘 要:提出了一种双三相异步电动机的建模新方法。基于磁动势和功率不变的原则，首先将双三 相异步电机的两套三相绕组等效变换为两套两相绕组,再将这两套两相绕组等效变换为两相绕组。 然后应用成熟的异步电机在两相静止坐标系下的数学模型，建立了双三相异步电动机在α-β坐标系 下的数学模型，并应用Matlab/Simulink 建立了其仿真模型。设计制作了一台4 极、1.1kW 的双三 相异步电动机，进行了仿真和试验对比研究。结果表明，仿真结果与试验结果吻合，两者间的最大 误差在2% 以下。可见，这种基于绕组复变换的建模方法是有效和正确的。 关键词：绕组复变换；双三相异步电动机；等效；仿真；试验 中图分类号：TM343 文献标识码：A 文章编号：1004-731X (2011) 06-1069-04 Modeling on Dual Three-phase Induction Machine Based on Double Winding Transformation WANG Bu-lai, HUANG Lei, GU Wei, WU Wei-min (Dept. of Electrical Automation, Shanghai Maritime University, Shanghai 200135, China) Abstract: A novel mathematic model for a dual three-phase induc tion machine was proposed. An equivalent dual two-phase windings was built based on same magnetomotive force and power. Then the dual two-phase windings were transformed to two-phase windings. With the mathematical model of the electrical machine in the stationary reference frame, the model of a dual three-phase induction machine was determined. A 4 pole 1.1 kW dual three-phase induction machine was simulated and tested. Compared the simulation results with corresponding test results, the maximum error is lower than 2%. So this double winding transformation and modeling method are validated and correct. Key words: double winding transformation; dual three-phase induction machine; equivalent; simulation; test 1 引 言