5566asdasdsad(国外英文资料).docVIP

5566asdasdsad The stability of arc plasma cutting machine directly affects the quality of cutting, plasma arc unstable phenomenon, can lead to uneven, incision tumor volume and other defects, reduce the life of elements will lead to the control system, the frequent replacement of the nozzle and the electrode. Analyze and propose solutions to this phenomenon. 1. air pressure is too low Plasma cutting machine work, such as pressure is much lower than the pressure instructions required, which means that the plasma arc jet velocity decreases, the input air flow is less than the specified value, the plasma arc can form a high energy and high speed, resulting in poor quality, cut through the incision, incision tumor volume phenomenon. The reasons for the lack of air pressure are: the air compressor input air is insufficient, the cutting machine air valve adjustment pressure is too low, there is oil in the solenoid valve, gas road is not smooth, etc.. The solution is to observe the output pressure of the air compressor before use. If it does not meet the requirements, adjust the pressure or overhaul the air compressor. If the input pressure has reached the requirements, should check air filter relief pressure valve regulation is correct, the gauge show can meet the cutting requirements. Otherwise, the air filter pressure reducing valve shall be regularly maintained to ensure that the input air is dry and oil-free. If the input air quality is poor, it will cause oil pollution in the solenoid valve, the valve opening is difficult, the valve port can not be fully opened. In addition, the torch nozzle pressure is too low, also need to change the electromagnetic valve; the gas path section smaller can also cause the pressure is too low, can be replaced according to the instructions of trachea. 2. pressure is too high If the input air pressure is much more than 0.45MPa, the large air flow will blow out the concentrated arc column after the formation of the plasma arc, so that th