shiyong（国外英文资料）.docVIP

shiyong Principle of reinforcing bar anchorage: 1, the tensile steel beam in bending the anchor end bearing, the bent anchor straight section is larger than 0.4laE, the hook section is 15d and the side column should enter the vertical anchoring zone, and should make the reinforcement hook not parallel contact with the column longitudinal reinforcement principle (side column vertical anchorage zone width is that the 5D to the center line of the columns and column longitudinal reinforcement inside); 2. The principle that the longitudinal reinforcement of the longitudinal bearing should not take the protective layer completely at the end bearing. When the horizontal section is taking the concrete protection layer, the bent hook section should be inserted into the reinforced concrete inside the end angle reinforcement; 3, when the seismic frame beam to column bearing straight anchorage, longitudinal reinforcement should be greater than or equal to Lae and the principle of +5d line; 4, the beam by tension bars, bending hook for 15d, column partial pull longitudinal reinforcement bending hook, steel structure bending hook for 12D principle; 5, the wall of the first vertical reinforcement, the first reinforcement of the plate from the recent component of the parallel, steel for the wall, vertical steel and plate reinforcement distribution spacing of 1/2 principle; 6, when the two component reinforcement overlap, not repeated settings and take the principle of big; 7. The principle that the steel bar anchorage shall not be in parallel contact. 1, variable cross-section column wall reinforcement anchor is 1.5Lae 2, wall column longitudinal reinforcement anchorage is 1.6Lae 3, the upper column than the lower column more steel anchorage 1.2Lae 4, the lower column than the upper column more steel anchor 1.2Lae 5, when the diameter of the upper column is greater than the lower column, the connecting position of the lower column should be moved to the upper end of the column, and