单片机实验（国外英文资料）.docVIP

单片机实验 Proteus microcontroller simulation experiment handouts Catalog Experiment 1. Proteus cognition experiment Experiment two the use of P1 port experiment Experiment three read and write memory RAM Experiment four lit the LED experiment Experiment five 4X4 matrix keyboard and eight section digital tube display experiment Experiment six program jump table Experiment seven, 1602LCD display experiment Appendix experimental source code Experiment 1 Proteus cognition experiment (1) First, the purpose of the experiment (1) familiar with the use of Protues, including installation, use, interface and so on (2) the preparation and use of learning delay subroutine. (3) learn some basic operations of Protues: including adding components, editing components, interconnecting components and so on Two, experimental content (1) familiar with Protuess interface and how to use it as required (2) practice the following example and learn the basic operation of Protues Here is the work interface for ISIS: Add components to the list of components: the elements used in this example are: ATMEGA16, LM016L (LCD1602), land, and oscilloscope Click the P button to appear the pick component dialog box In the dialog box, type ATMEGA16. As shown in the following figure The same way to find LM016L components 2, put components: in the component list, select ATMEGA16 in the left key, in the schematic edit box, click the left key, so that it is placed in the schematic edit window, the same way to place LM016L Add click select model icon in the toolbar, appear below, select the ground and the principle diagram of the edit window left click, this is placed to the principle diagram of the edit window. Add the oscilloscope: the left button selects the dialog box in the model toolbar, and the appropriate oscilloscope button is selected. The same method is added to the schematic editor window. 3, connection: AVR, LCD VSS, VDD, VEE, GND=0 do not connect, the default connection, where VSS=0, VDD=5, VEE=-5v