实验拓扑与配置说明.docVIP

实验拓扑及配置说明 注：以下蓝色字体部分是设备进行相应配置后自动生成的提示信息或日志信息。 S2328G配置步骤及配置说明： Ruijieen \\进入特权层 Ruijie#conf \\进入全局配置层 Enter configuration commands, one per line. End with CNTL/Z. Ruijie(config)#host S23 \\配置主机名为S23 S23(config)#vlan 10 HYPERLINK \\\\创建VLAN10 \\创建VLAN10并命名为renshi S23(config-vlan)#name renshi S23(config-vlan)#vlan 20 HYPERLINK \\\\创建VLAN20 \\创建VLAN20并命名为caiwu S23(config-vlan)#name caiwu S23(config-vlan)#vlan 100 HYPERLINK \\\\创建VLAN100 \\创建VLAN100并命名为guanli S23(config-vlan)#name guanli S23(config-vlan)#exi S23(config)#int ran f 0/1-10 HYPERLINK \\\\将1-10 \\将1-10口划入VLAN10 S23(config-if-range)#sw acc vl 10 S23(config-if-range)#int ran f 0/11-20 HYPERLINK \\\\将11-20 \\将11-20口划入VLAN20 S23(config-if-range)#sw acc vl 20 S23(config-if-range)#exi S23(config)#spanning-tree \\开启生成树，防止环路 Enable spanning-tree. *Dec 10 16:58:24: %SPANTREE-5-TOPOTRAP: Topology Change Trap for instance 0. *Dec 10 16:58:39: %SPANTREE-5-TOPOTRAP: Topology Change Trap. S23(config)#span mo rstp \\配置生成树的模式为RSTP S23(config)#int ran f 0/1-24 HYPERLINK \\\\在用户接口1-24 \\在用户接口1-24开启bpduguard和portfast S23(config-if-range)#span bpduguard enable S23(config-if-range)#span portfast %Warning: portfast should only be enabled on ports connected to a single host. Connecting hubs, switches, bridges to this interface when portfast is enabled,can cause temporary loops. %Warning: portfast should only be enabled on ports connected to a single host. Connecting hubs, switches, bridges to this interface when portfast is enabled,can cause temporary loops. %Warning: portfast should only be enabled on ports connected to a single host. Connecting hubs, switches, bridges to this interface when portfast is enabled,can cause temporary loops. %Warning: portfast should only be enabled on ports connected to a single host. Connecting hubs, switches, bridges to this interface when portfast is enabled,ca