中国石油北京《机械基础(设计与制造)》第二阶段在线作业（China petroleum Beijing machinery foundation (design and manufacturing) the second stage of online homework）.doc

中国石油北京《机械基础(设计与制造)》第二阶段在线作业（China petroleum Beijing machinery foundation (design and manufacturing) the second stage of online homework） 14 spring 13 autumn 13 spring China petroleum university petrochina Beijing - second stage online homework Single option Problem 1 belt drive, elastic slide () A, it can be avoided when tension is sufficient B, the transmission power is less than an hour C. It can be avoided when the small belt wheel is large enough D is inevitable The maximum stress sigma Max is equal to () A, 1 b1 + + sigma sigma sigma c B, 1 + sigma sigma sigma b2 + c C, sigma 2 b1 + + sigma sigma C D, sigma 2 + sigma sigma b2 + c The maximum stress of the belt occurs when the transmission speed is decelerated. A, take away from the big wheel B, bring around the big wheel C, take away from the small wheel D. take the belt around the small wheel When the V belt transmission is designed, the base diameter of the small band wheel is greater than that of dmin. The main purpose is (). A, the Angle of the transmission is not too small B. The bending stress of the belt will not be excessive C, increase the friction between belt and wheel D, easy to make wheel The design criteria for the belt drive are guaranteed to be within the required working period (). No excessive wear and tear B. No skid and fatigue damage C. No elastic sliding occurs D. no wear and tear In the 6th tape drive, the initial pull is F0, the tension is the F1, the loose side tension is F2, and the circle force F is equal to (). A, F0 - F2 B, F1 - F0 C, F1 + F2 D, F1, F2 The reason for the slippage of the belt drive is () A, tension tension F1 is greater than the friction limit value B, the tightening force F2 is greater than the friction limit value C, circle force F is greater than the friction limit value D, 0.5 (F1 + F2) is greater than the friction limit value 8 ordinary v-belt transmission, small pulley Angle alpha should be not less than 120 °, mainly to () A, reduce the elastic slide B. Reduce