热镀锌工艺技术的发展现状（The status quo of hot galvanizing process technology）.docVIP

热镀锌工艺技术的发展现状（The status quo of hot galvanizing process technology） The development status of continuous hot galvanizing technology for strip steel Hot pure zinc plating (GI, galvanized) products and alloying (GA, galvannealed) products with excellent corrosion resistant performance, costs are relatively low, and with the progress of hot galvanizing technology, the product surface quality can be comparable to those, electric galvanized products almost thus has been widely used in the car. At present, the Japanese sedan basically USES the GA board as the outer plate, and the automobile manufacturing industry in Europe and the United States is constantly increasing the use of hot-dip galvanized steel. Car plate, especially in practical auto outer panel demand increased at the same time, the surface quality of hot dip galvanized products and formability are also put forward higher and higher requirements, it is the requirement of this market is increasing greatly promoted the progress of strip continuous hot galvanizing technology. Continuous hot-dip galvanizing process of strip steel and its improvement nbsp1 hot galvanizing process have been introduced in three kinds of continuous hot-dip galvanizing process, such as senkimmel method, improved sendkimmel method and united steel joint method. Jimmy, Jimmys method and the improved sen method is simple, the product cost is low, but as a result of using direct flame heating, although plate on the surface of the rolling oil can burn, but the impact the strip surface quality, is unfavorable to produce thin specifications products. Steel union law set up in front of the annealing furnace cleaning section, using electrolytic degreasing, steel strip surface stains can be removed completely, in addition, the process using total radiation tube reduction furnace heating strip steel, galvanized layer surface quality is better. The process is relatively complex, thermal efficiency is low, but it can produce better surface quality