用3DS MAX路径约束法制作动画（The method is used to animate the method with 3DS MAX path constraint）.docVIP

用3DS MAX路径约束法制作动画（The method is used to animate the method with 3DS MAX path constraint） If you want to make an object moving along a specified path, path in earlier versions is the way to implement by specifying the path controller, in R4.0 version we can through the menu assigned to the objects path constraint, you can also use the previously mentioned specified path constraint method of the controller, the resulting effect is the same, both objects that can be controlled by a curve along the curve direction, or weighted average position on multiple curve movement. The path curve can be any type of curve, and it can make any standard animation on its own, and it can animate its children. All effects work and constrain objects. Thanks to its flexible animation capabilities, this method is used in many animations. The general method for making path constraints is as follows: select an object or an object group to select Animation menu % 26gt on the menu. Constraints % 26 gt; Path Constraint, to select the target mode, choose from the window as the curve of the motion Path, or in the animation palette, choose position controller, for its designated controller as the Path to the controller, this method can also be done in the trajectory of the window. Then the path constraint parameters in the animation panel can be adjusted to complete the animation. Its important to note that once you specify the path constraint, in your position controller point2 format in a list of the controller, which increases the path constraint, the location of the object is determined by its path constraint, in Windows mobile (in R4.0 can move along the path). The parameters of the path constraint are not too many, and the parameters are well understood. Were just doing a simple introduction: Add Path (Add Path) : select this button to Add a new Path and the existing Path to apply constraints to the object. Delete path (Delete path) : this button is used to remove the path from the path lis