川大《建筑结构设计(ⅰ)1412》13春在线作业2（Architectural structure design (I) 1412 13 spring online homework 2）.doc

川大《建筑结构设计(ⅰ)1412》13春在线作业2（Architectural structure design (I) 1412 13 spring online homework 2） Sichuan (Ⅰ) 1412 for design of building structure of 13 spring online homework 2 14 spring 13 autumn have the total score: 100 test time: -- Single topic selection (50 test questions, 100 points.) 1. The section size of the beam must be limited (not too small) when calculating the shear bearing capacity of the beam. The purpose is to prevent the following damage (). A. slope failure B. Shear failure C. baroclinic damage D. Bending failure of oblique section Full mark: 2 The total loss value of the prestressed concrete component should not be less than the following item (). A. 80N/square mm B. 100N/square mm C. 90N/square mm D. 110N/sq mm Full mark: 2 3. The new masonry of the mortar has not been hardened in the construction stage, and the strength of the masonry is determined by the following items: A. Determination of mortar strength is zero B. Zero calculation C. 50% calculation D. 75% calculation Full mark: 2 4. The average fracture spacing of reinforced concrete members is not related to the following factors () A. concrete strength grade B. Thickness of concrete cover C. longitudinal tensile reinforcement diameter D. Longitudinal reinforcement ratio Full mark: 2 5. T A. a. B. b. C. c. D. d. Full mark: 2 6. 4 A. a. B. b. C. c. D. d. Full mark: 2 7. The bearing capacity of the screw column shall not exceed 1.5 times of the normal column, which is to satisfy the following requirements () A. limit section size B. no brittle damage occurs C. The outer concrete shall not fall off during normal use D. Guarantee ductility of components Full mark: 2 8. In 1056, the wooden tower, which was built in yingxian county, Shanxi Province, was correct A. The tower is 80m, with a total of 12 floors The tower is 67.3 m, nine floors C. Tower is 30m, with a total of 5 floors D. tower 46.6, 6 floors Full mark: 2 9. In the gradual loading process of the beam, the following situations occur