UG 3B格式线切割后置处理的开发（UG 3B format line cutting post-processing development）.docVIP

UG 3B格式线切割后置处理的开发（UG 3B format line cutting post-processing development） STRONG Abstract: my post processor has been improved several times and has been running steadily for over a year now. It works well. At the same time, I hope that this article can give readers some enlightenment. /STRONG/PSTRONG the /STRONGBRnbsp.; can process a variety of narrow groove, small rounded line cutting, on hardness is not sensitive, especially after quenching and processing, low cost, convenient operation, so in the processing industry is an indispensable technical means. In recent years, the rapid development of wire cutting machine, the control system is integrating with the world gradually, control system of G code has gradually become the mainstream, but in some low-end products, especially in old machine tool control system, 3B format is almost monopolized, our factory is specializing in the production of automobile mould factory, there are many old thread cutting machine. Although our factory also has advanced the WEDM machine, but the processing cost of wire machine is low, the environmental requirements are low, so it has been cutting section of the main line. /P first, we weave wire cutting program is a two development program in AutoCAD, and later units on the UG, but not UG common post processing 3B code format, we put the UG line conversion to Auto CAD, often because of the two kinds of software does not follow good and repeated adjustments, time-consuming, powerful function of our purchase of expensive UG software can not exert its cutting line. Later, with the in-depth understanding of UG, found that can also handle the 3B format, the following describes, and I hope to enlighten you. /PSTRONG two.3B code programming rules /STRONGBR 1.3B code format: B x nbsp B; ynbsp B; j G Z, B x, y, symbol segmentation, J value, to microns. J is the count length, G is the counting direction, and Z is the processing instruction. /P 2. processing in