22K开关使用方法（22K switch usage）.docVIP

22K开关使用方法（22K switch usage） Thunder machine 22K switch using method 2006-08-29 13:14:23 medium 0/22 k, DisEcq switch is triggered by the 22 k pulse signal from the receiver to relay or electronic switch to control the switch, they are all through the satellite antenna LNB connected to the receiver of coaxial cable transmission of control signal, dont need to switch a separate line. For the control of DisEcq, the control of DisEcq can be set directly from the menu. However, there is no direct control option on the 22KHz pulse opening and closing on the 4X0 machine menu, which is very confusing for many burn friends when using the 22K switch. The conception of this article is through analyzing the working principle of DisEcq and 22 k switch, let everybody understand profoundly 4 x0 TV receiver the control mechanism of them, in the practice of the many star receiving system, can flexible use DisEcq and 22 k switch, reasonably set the two switches with the 4 x0 machine menu organically combined, to play the greatest potential to 4 x0 receiver. 2k pulse mid-frequency switching switch The 2k pulse intermediate frequency switch is not used for binary switching in the first place, but is used for the two high and low vibration switches of the ku-band dual-ben-oscillator LNB (hf head). Because the ku-band frequencies range from 10.7 GHz to 12.75 GHz, the bandwidth is much higher than the frequency range of the receiver medium frequency input of 950 ~ 2150 MHZ. In order to be able to make the receiver can cover the whole Ku band, so the Ku band is divided into 10.7 ~ 11.9 GHz and 11.55 ~ 12.75 GHz two frequency interval, corresponding use LNB 9.75 GHz and 9.75 GHz two this vibration, to achieve the Ku band receive coverage. So this 9.750/10.600 GHz double prime is also known as general hf head or full frequency band. The 9.750/10.600 GHz dual oscillator LNB is performed by the 22KHz pulse signal to complete the switch between these two oscillations. For some other brands, the