结果与讨论-《渗剂中铝粉含量对Cu基Ni镀层表面Cr-Al渗层组织和性能的影响》（Results and discussion -- the influence of the content of aluminium powder in the penetrant on the microstructure and properties of Cr-Al infiltrated layer on the surface of Cu b.docVIP

下载本文档

2
0
约1.39万字
约 9页
2017-07-22 发布于河南
举报
版权申诉

结果与讨论-《渗剂中铝粉含量对Cu基Ni镀层表面Cr-Al渗层组织和性能的影响》（Results and discussion -- the influence of the content of aluminium powder in the penetrant on the microstructure and properties of Cr-Al infiltrated layer on the surface of Cu b.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

结果与讨论-《渗剂中铝粉含量对Cu基Ni镀层表面Cr-Al渗层组织和性能的影响》（Results and discussion -- the influence of the content of aluminium powder in the penetrant on the microstructure and properties of Cr-Al infiltrated layer on the surface of Cu b 2 results and discussion. Fig. 2.1 influence of aluminum powder content on Microstructure of carburized layer. Figure 1 is the surface morphology of infiltrated layer after infiltration of 1~4. When the No. 1 penetrant is used, the surface of the layer is relatively flat and dense, with no obvious voids (Figure 1 (a)). The EDS of the A zone on the surface of the infiltrated layer shows that the surface of the carburized layer mainly contains elements Ni and Cr. At the same time, contains lower concentrations of Al, O elements. This is due to the use of argon in the process of washing the furnace before the infiltration process. It is inevitable to maintain a partial pressure of oxygen in the furnace and react with metal in the process of heating to form oxides. Compared with figure 1 (a), the surface size of the infiltrated layer decreases with the use of No. 2 penetrant. EDS shows that the atomic concentration of Cr and Al elements increases on the surface of the nitrided layer, as shown in table 1. With the No. 3 penetrating agent, the surface of the infiltrated layer is rough, and the scattered white particles are scattered. The voids in the surface of the layer appear larger (Figure 1 (c)). EDS shows that the concentration of Cr atom reaches 28.97% (atomic fraction, the same below), and the concentration of Al atom is 42. 68%. With the No. 4 penetrating agent, the surface of the infiltrated layer is fine and there is no obvious cavity (Figure 1 (d)). EDS shows that the surface of the percolation layer mainly contains elements Al and Ni, in which the atomic concentration of Al is as high as 56.09%, the concentration of Ni is 42.50%, and the atomic concentration of element Cr is very low, which is 0.9%. According to the Ni-Al two element phase diag