G代码对照表（G code synopsis）.docVIP

G代码对照表（G code synopsis） SINUMERIK G code Address meaning, assignment description, programming D tool mark 0... 9 integers, without symbols, used for a tool T... Compensation parameter: D0 represents the compensation value =0, a tool has 9 D numbers at most, D... F 0.001... 99999.999 the feed rate of the tool / workpiece corresponds to G94 or G95, and the units are mm / min or mm / rev F... F feed rate (programmed dwell time with G4) 0.001... 99999.999 dwell time, unit G4 F... Run alone The G G function (prepared function word) has previously specified that the G function is divided by the G functional group, and that only one G function instruction in one of the G functional groups can be found in a program segment. The G function is active by mode (until it is replaced by other functions in the same group), or in the program segment. G function group: G... G0 quick movement 1: motion instruction G0 X... Z... G1 linear interpolation (interpolation) Modal effective G1 X... Z... F... G2 clockwise circular interpolation G2 X... Z... I... K...... The center of the circle and the end G2 X... CR=... F... Radius and end point G2 AR=... I... F... And the center angle; G2 AR=... X... F... The angle and end point; G3 counterclockwise arc interpolation G3... ; Others with G2 CIP middle point arc interpolation CIPX... Z... I1=... K1=... F... G33 cutting of constant pitch thread S... M... Spindle speed, direction G33Z... K... In the direction of the Z axis Compensating jig tapping G331 without compensating clamps, cutting internal thread N10, SPOS= The spindle is in position adjustment N20 G331 Z... K... S... In the Z axis, without compensating clamps, tap Of right or left threads through the pitch of a thread Symbols (such as K+) are determined: Same as M3 - same as M4 G332 cutting internal threads without compensating clamps. G332 Z retract... K... Cutting threads without compensating fixtures. Z retract; pitch symbol G331 Transition arc interpolation with tangent CT N10... N2