常见EMC问题（Common EMC problems）.docVIP

常见EMC问题（Common EMC problems） Common EMC issues 1. Why do electromagnetic compatibility design for products? Answer: Meet product functional requirements, reduce commissioning time, so that products meet the requirements of electromagnetic compatibility standards, so that products will not be in the system of other equipment to generate electromagnetic interference. 2. What are the various aspects of electromagnetic compatibility design for products? Answer: circuit design (including device selection), software design, circuit board design, shielding structure, signal line/power line filter, circuit grounding mode design. 3. In the field of electromagnetic compatibility, why always use DB (db) unit description? How many dBmV are 10mV? A: Because the amplitude and frequency range of the description is very wide, it is easier to represent the graph with logarithmic coordinates, and DB is the unit with logarithmic representation, 10mV is 20dBmV. 4. Why does the Spectrum Analyzer not observe the electrostatic discharge and other transient disturbances? A: Because the Spectrum analyzer is a narrowband sweep receiver, it receives only the energy within a certain frequency range at a given moment. and electrostatic discharge, such as transient interference is a pulse interference, the spectrum range is very wide, but the time is very short, so that the spectrum analyzer in the transient interference occurs only a small part of its total energy, can not reflect the actual interference. 5. In the field of electromagnetic interference problem diagnosis, often need to use near-field probes and spectrum analyzer, how to use coaxial cable to make a simple near-field probe? A: The outer layer (shielding layer) of coaxial cable is peeled off, the core line is exposed, and the core line is turned into a diameter and a small ring ($number turn), welded on the outer floor. 6. A device, the original electromagnetic emission intensity is 300mv/m, plus shielding box, radiation emission r