厂商维修硬盘的方法（Method for repairing hard disk of manufacturer）.docVIP

厂商维修硬盘的方法（Method for repairing hard disk of manufacturer） How to repair the hard disk by the manufacturer In fact, it can be explained to everyone first, even from the manufacturers out of the brand-new hard disk, their platters are not a bit defective. Because of the precision of disk platters, there are very high requirements for both production environments and movement, and even a speck of dust, a slight collision, can result from several to hundreds of bad sectors. So, in general, according to the current 120GB of hard disk capacity, a new platter even if there are thousands of bad sectors is not impossible. But hard disk manufacturers will use specialized equipment to scan platters, record the bad sectors and the unstable sectors of the magnetic medium, make a list of hard disk defects, write into the system reservation area, and close the sectors through the control program, and the control program of the hard disk will not read these areas when the hard disk is read. Todays hard drives are written into the systems reserved area because of the complexity of their functions and parameters. In this way, because the problem of the sector in the level of control has been closed off, so that users no matter what format and partition software will not see this part of the information, it looks like there is really no bad way. At the same time, there is another closed area in the hard disk, also known as the reserve capacity, they are really not the problem of a good disk, but for some reason was closed up. For example, a hard disk is 60GB, and the disc capacity is 40GB, then the two-disc disk must be closed to 20GB of capacity (disk production line is certain, manufacturers in order to reduce costs, will only produce a capacity of the disk, by blocking the different capacity of the area to obtain different actual hard disk capacity). Figure out the production principle of the hard disk, so how to repair the hard disk is very well understood. For the control circuit