几款专用注塑机螺杆简单介绍（Several special injection molding machine screw is introduced briefly）.docVIP

几款专用注塑机螺杆简单介绍（Several special injection molding machine screw is introduced briefly） Injection molding machine temperature rise too high treatment method (1) according to different load requirements, often check and adjust the overflow valve pressure, make it just right. (2) reasonable choice of hydraulic oil, especially oil viscosity, under the conditions permit, try to use a lower viscosity, in order to reduce viscosity, friction loss. (3) improve the lubrication condition of moving parts, to reduce friction loss, reduce work load, reduce fever (4) to improve the assembling quality of hydraulic components and hydraulic system and its precision, strict control of the matching gap and improve the lubrication conditions of the. The sealing material with small friction coefficient and improved sealing structure are adopted to reduce the starting force of the hydraulic cylinder as much as possible, so as to reduce the heat generated by mechanical friction loss. (5) add cooling equipment when necessary Several special injection molding machine screw is introduced briefly (1) characteristics of PC material (polycarbonate): 1. amorphous plastic, no obvious melting point, glass temperature of 140 degrees -160 DEG C, melting temperature of 215 degrees -225 DEG C, molding temperature of 230 degrees -320 DEG c; 2., large viscosity, high processing temperature, narrow range, easy to break, the use of screw to avoid overheating phenomenon; 3. sensitive to moisture, high temperature resin hydrolysis, drying temperature 120 degrees -130 DEG C, time 4 hours or so. Parameter selection: 1.L/D for its good thermal stability and high viscosity, in order to improve the plasticizing effect, choose the large aspect ratio as far as possible; 2., because of its wide melting temperature range, the feeding section length, homogenization section is short, the compression ratio is moderate, in order to increase the plasticizing effect, we can choose the barrier type Rubber head; 3. such as add