怎样设置局域网共享（How to set LAN share）.docVIP

怎样设置局域网共享（How to set LAN share） Open sharing on the other side of the host, and in the group policy in open classic user login mode, set up a user and password on the other side, so that you can open the group policy in the operation of gpedit.msc in the computer configuration in Windows settings in the local security settings to find network access security options -- -- Strategy: sharing local accounts and safe mode will be changed to the classic local guests, you can. 1. is the hardware connected? The first thing we need to make sure that the two computers are connected on the network, that is to say, is the hardware connected or not, before we can connect to the computer. You can use the ping command to detect through start run. The two computers are the best in their respective manual settings (such as the 172.192.0.1 IP 255.255.255.0 subnet mask and the other is 172.192.0.2 the same subnet mask (172.192.1.2) using the ping command in IP is to use 172.192.0.1 computer using Ping 172.192.0.1 (IP) is used on the 172.192.0.2) two computer is connected. If connected, you can, and if not, then check the hardware problems, such as network card is not good, there is no plug in, the network is not good, generally these 3 cases. About the specific setting steps of IP: My computer - control panel - network connections - local connections, right-click properties - Routine - find TCP/IP protocol - properties below the points - Routine - select using the following IP address, and then fill in the IP and subnet mask. 2. in the network neighbors can not see each other Please make sure that your working group is correct and that both parties should be in the same working group as follows: Electric shock my computer right - Property - computer name can see your workgroup. If you want to change it, just click change. 3. appear word: you may not have permission to use network resources. Please contact the administrator of this server to find out if you have access rights When t