温控（temperature control）.docVIP

温控（temperature control） The - Re:Re:Re: electric water heater telephone remote control system The power carrier terminal mainly includes power carrier modem circuit, power line coupling circuit, CPU circuit, and communication interface circuit with the water heater controller. When the call controller sends a command, by the power transmission line 6 is modulated digital signal like coupling network and filter, into the TDA5051, after decoding the digital signal into CPU flowunpack tread it correction after the water heater to open and shut down to set temperature and operation into the water heater controller. The operation confirmation information is then returned to the CPU via the communication interface circuit, which is coupled to the AC 220V/50Hz power line via a coupling network via CPU encoding and TDA5051 modulation. The telephone controller receives the power line to return information, the TDA5051 demodulation, digital demodulation signal into the telephone controller CPU, CPU voice control interface circuit according to the confirmed information returned, voice issued operation is completed that is coupled to the telephone line voice prompt to the user. At this point, the entire operation has been completed. When the user does not set, hang up the phone. When the telephone remote controller detects that the other party is on the hook, the telephone line is automatically hung up after the delay. The whole system is re entering the waiting state and ready for the next operation. The block diagram of the whole system is shown in figure 1. The - Re:Re: electric water heater telephone remote control system 1 system structure The system is mainly composed of a telephone controller connected with the telephone and an embedded power carrier terminal connected with the water heater. The telephone controller includes control circuit of cardiac CPU phone ringing detection circuit, automatic telephone note and hang up the circuit, DTMF signal decoding circuit, voic