轴肩下压量对搅拌摩擦焊搭接焊缝界面迁移的影响 - Ingenta Connect.PDF

43 Influence of Plunge Depth of Shoulder on Interface Migration of Friction Stir Lap Welds , , ( , 330063) WEI Peng, ING Li, U Weiping (School of Aeronautical Manufacturing Engineering,Nanchang Hangkong University,Nanchang 330063, China) : 2mm LF6 , :, , ,, ; , 0. 18mm , ; ,,; , ;, : ; ; ; : TG456 : A :2011) Abstract : Friction stir lap welds of 2mm thick plates of LF6 aluminum alloy were conducted using the cylindrical tool with lefthand thread, the influence of plunge depth of shoulder on interface migration of friction stir lap welds was investigated. The results show that the interfaces at the advancing side and retreating side of the welds move toward the upper surface of welds, when the interface at the re treating side is up to the top of weld, it will transfers horizontally to weld center and can be largest extended to the advancing side whilethe interface at the advancing side is only moved at the advancing side. T he height of interfacemigration at the retreating side rises with the increase of the plunge depth of shoulder, but the height will be reduced when the plunge depth of shoulder is more than 0. 18mm. The height at the advancing side augments with the increase of the plunge depth of shoulder. Micro morphology of transferred interface was observed, the interface at the retreating side is not joining when it transfers upwards. And then it is intermittent distribution when it moves to the top of weld. Interface linebecomes a tight joining when it transfers horizontally to weld center. The transferred in terface at th