班组安全教育内容（Team safety education content）.docVIP

班组安全教育内容（Team safety education content） Reinforcement team safety production education content (level three education) 1, each worker should consciously abide by the laws and regulations and the company, the project Department of the various rules and regulations. 2, steel, semi-finished products should be in accordance with specifications, varieties are stacked neatly. The production site should be flat, the operation platform should be stable, and the lighting fixtures must be covered with mesh. 3, straighten the steel bar, the card head to secure, the anchor to be strong and firm, pull along the tendons within 2 meters prohibited pedestrians. Manual grinding straighten, prohibit the use of chest, belly contact push rod; and slow release, not released at once. 4, the expansion of steel reinforcement to a lock, to prevent rebound, cut off the first step with the foot firmly. 5, at high altitude, deep steel banding and installation frame, scaffold erection and ma. 6, lashing column, wall reinforcement, shall not stand on the steel skeleton and climbing skeleton up and down. Column bars below 4 meters, and the weight is not big, can be on the ground or floor lashing, whole erect; column bars in more than 4 meters should set up work platform; column and beam skeleton temporary support brace, in case of dumping. 7, lashing the base reinforcement, should be placed according to the construction operation rules of steel support (horse stool), put up the upper reinforcement, shall not arbitrarily reduce bracket or horse stool. 8, co-operation reinforced, starting off, turn, action to stop the same, manual loading and transfer shall not be in the same vertical line; steel piling to be distributed, safe, to prevent dumping and collapse. 9, spot welding, butt welding reinforcement, welding machine should be located in a dry place, welding machine should have protective cover, and placed stable and firm, the power supply through leakage protector, wire insulation is good. 10,