电厂设备热工专业常见故障分析与处理（Analysis and treatment of common faults in thermal engineering specialty of power plant）.docVIP

电厂设备热工专业常见故障分析与处理（Analysis and treatment of common faults in thermal engineering specialty of power plant） Analysis and treatment of common faults in thermal engineering specialty of power plant 1 、 sampling table pipe plugging The pressure and differential pressure of the feeder in the coal mill, air preheater and other parts are directly sampled by the pressure pipe, and the blockage of the sampling meter often appears. Failure phenomenon: the performance of the pressure is no change, differential pressure rise, the switch does not move, the pressure rise, differential pressure drop, etc.. Failure cause: 1) Design defects: in the design phase, there is no sampling tube blowing device, and the sampling tube is often blocked by coal dust or ash. Although the design of the sampling tube purging device has been designed in the two stage, it has not been used properly. After this problem was found, the relevant personnel in the heat treatment room were contacted with the relevant blowing device, which was not approved. The main concern was that the operation and operation of the sweeping device would affect the operating conditions of the equipment. 2) There is no buffer tank: there is no buffer tank at the sampling port. 3) Purge is not complete: Tuodian a sampling design of coal mill as a sampling port with multiple devices, such as pressure, differential pressure, switches and other reasons, conditions, time and measures to purge, not completely all the sample line all clean and purge left hidden trouble Disposal method: purging Treatment effect: the two phase equipment is now the device after the problem, first blowing, and then sweep device for use, after the use of sweeping device, the number of sweeping significantly reduced. In case of minor repairs or overhaul, all the sampling tube completely purge after all sampling purging device is put into use, I believe there will be a great improvement. Limited to the equipment in the first phase, and now there is only