管膜式曝气器（Tubular membrane aerator）.docVIP

管膜式曝气器（Tubular membrane aerator） Tubular membrane aerator 1, the main technical parameters The medium air temperature is 0~40 degrees Mixture pH 4~10, dynamic viscosity 7~23 * 10-6 Suitable for working medium, mixed sewage containing domestic sewage and industrial sewage, suitable for working water depth of 3-8 M The mixture density is less than 1.2 * 103kg/m3 humidity 10 ~ 90% Air pipe pressure 58.8kPa pool effective depth 5.25M The area of single tank aeration was 1950m2, and the number of pool was 1 The single largest pool of 200m3/min power supply efficiency higher than 3.5kgO2/kW H? The service area is larger than 2.0m2/m aeration pipe diameter 64mm The resistance loss is less than or equal to 50mbar the total number of membrane tube type microporous aeration device 1800 sets The bubble diameter is 0.8-1.9mm, and the length of single aerator is 1000mm (1) the utilization rate of oxygen: water determination in aeration of 6m3/h water depth of 4.5 meters, the oxygen utilization rate of more than 20%, submerged water depth of 6 meters up to more than 30%. (2) power efficiency: when the ventilation volume is 6m3/h and water depth above 4.5 meters, it is greater than 3.5kgO2/kW.h (3) applicable air flow: the optimum range of aeration: 8-10mN3/h per unit; Minimum aeration rate: 2mN3/h per unit Maximum aeration rate: 12mN3/h per unit Critical aeration rate: 20mN3/h per unit 2, the main structure and technical requirements (1) aeration membrane adopts import three yuan ethylene propylene rubber (EPDM), diaphragm 1.5 + 0.10mm, specific gravity less than 1.2g/cm3. Diaphragm should be heat-resistant, ozone resistance, climate resistance, chemical stability and other characteristics, tear strength should be greater than 10 N/ mm2, tensile coefficient should be greater than 450%, elasticity should be greater than 30%, the torsional strength should be greater than 15 N/mm. Tensile strength: 8.8 Newtons /mm2; maximum ductility: 400%; tear strength: 9 Newtons /mm; hardness: