涡流管介绍（Introduction of vortex tube）.docVIP

涡流管介绍（Introduction of vortex tube） Introduction of vortex tube Eddy current refrigeration and its application: The phenomenon of vortex tube is the 1930 French physicist George Lange found. The American AiRTX Pneumatic Technology International is one of the first companies to actually apply this physical phenomenon to practical industrial cooling solutions. The fluid rotates around the shaft -- like a tornado -- the flow of the fluid is called a vortex. Vortex refrigeration technology is also called expansion refrigeration technology to swirl, squeezed out from the air compressor compressed air through the vortex tube nozzle into a tangential cylindrical vortex generating cavity, the generator generating rotary airflow heat pipe (long) compared to bigger, the vortex chamber is located between the hot end and the cold end of the vortex tube. And they are connected. The vortex chamber formed by the hot end of the vortex flow into the vortex tube, vortex flow close to the inner surface of the vortex tube, the hot air is continuously discharged from the hot end, hot air produced a flow resistance in the hot end, the flow resistance in the vortex tube in the formation of enough negative pressure, the negative oppression makes a part of the air through the center of the vortex tube back to the cold end. This part of the air heat expansion air flow of the hot end and cold. When the high pressure air enters the vortex tube, it expands the volume of the gas and absorbs heat, and then produces eddy current in the vortex tube. The compressed air enters a vortex generator, and then the rotating airflow is forced into the heat pipe along the wall of the heat pipe at a rotational speed of 1000000rpm. At the end of the heat pipe, a small part of the air through the needle valve in the hot air way. The remaining air is returned at a lower rate through the center of the rotating air flowing into the heat pipe. A hot, slower rotating airstream passing through a rapidly rotating airst