数控车削中切削参数对表面质量的影响分析（Analysis of influence of cutting parameters on surface quality in NC turning）.docVIP

数控车削中切削参数对表面质量的影响分析（Analysis of influence of cutting parameters on surface quality in NC turning） Abstract: the selection of cutting parameters mainly depends on the level of process personnel, which is often determined by the process designers, and has certain blindness. The selection of cutting parameters of aluminum alloy in numerical control turning was studied. First of all, according to several parameters affecting the surface quality of the workpiece processing of 102 aluminum rod experiment on CK6136 CNC lathe, the experimental data and the experimental data were analyzed; secondly, research on the main parameters of the interaction, combined with the specific conditions, summarizes the selection method. Keywords: numerical control turning, cutting parameter, surface quality Abstract: when the machining accuracy and surface roughness requirements is high, she should consider finishing set aside an appropriate amount. The finishing allowance is generally smaller than the conventional turning allowance, usually taking 0.1 to 0.3mm. In addition, according to the experimental data, under normal circumstances, when the machined surface roughness value is Ral2.5, a coarse vehicle can meet the requirements. But when the machine tool stiffness difference, lack of motivation or she is too large, can be divided into several complete cutting processing, and cutting depth should be gradually reduced with the number of cutting; when the surface roughness of Ra1.0 ~ 1.6, it should take a small amount of cutting to completefinishing. The 4 conclusion is that the influence of spindle speed, feed speed and cutting depth on the surface quality of machined workpiece is obtained by experimental data. At the same time, through comparative analysis, we can see that when cutting material is aluminum alloy, the effect of cutting depth on surface quality is not significant, and the influence of feed speed on machining quality is remarkable. In the turning, the spindle speed and feed