pkpm中的一些相关参数的设定（The setting of some parameters in PKPM）.docVIP

pkpm中的一些相关参数的设定（The setting of some parameters in PKPM） A) horizontal force and overall coordinates: 1. Under normal circumstances take 0 degrees, planar complex (such as L shape, triangular) or structure nonorthogonal to resist lateral force, should be separately according to each direction Angle is a component to resist lateral force, but actually calculate by 0, 45 degrees of each one; When the program gives the direction of maximum seismic force, the calculation can be calculated according to the Angle of the direction, and the reinforcement takes the large value of the three. 2. According to the seismic code 5.1.1-2, when structure phase Angle is greater than 15 degrees component to resist lateral force, should be each component to resist lateral force are calculated separately, and the direction of horizontal seismic action, seismic action function, if a program to provide multiple directions should choose this functionality. B) concrete bulk density: The calculation of concrete calculation of reinforced concrete shall be greater than 25. The surface area and volume of different structural members are different than those of different decorative surfaces. Structure type frame structure frame shear wall structure Severe 2627 28 C) steel bulk density: generally 78, if the designer can be considered in the appropriate amount. D) number of skirts: 1: high regulation 4. 8. Rule 6: the aseismic level of the skirt building with the main building as a whole shall not be lower than that of the main building. The structure of the main building shall be appropriately strengthened in the upper and lower part of the roof of the skirt. So the number has to be given. 2: the number of layers is the number of calculations, which is equal to the number of layers of the skirt. Conversion layer: 1: the specified for the program decided to strengthen parts and transformation layer at the bottom of the upper and lower sti