遥控电风扇（Remote control electric fan）.doc

遥控电风扇（Remote control electric fan） The following code / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * description: * * * * connection method: J1 jumper short * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / # include reg51. H # include intrins. H # define NOP () _nop_ () / * define empty instruction * / # define uchar unsigned char # define uint unsigned int # define delayNOP (); {_nop_ (); _nop_ (); _nop_ (); _nop_ (); }; Void delay (uchar x); / / x * 0.14 MS Void delay1 (int ms); Void beep (void); Sbit IRIN highlights = P3 ^ 2; / / infrared receiver data line Sbit RELAY = P1 ^ 4; / / relay drive line Sbit BEEP = P1 ^ 5; / / buzzer drive line Uchar IRCOM [7]. Uchar cdis1 [] = { REMOTE CONTROL }; Uchar cdis2 [] = { ir-code: -- H }; / / LCD IO Sbit LCD_RW = P2 ^ 5; Sbit LCD_RS = P2 ^ 6; Sbit LCD_EN = P2 ^ 7; Unsigned char Y0. / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / Motor Sbit F1 = P1 ^ 0; P1 sbit F2 = ^ 1; Sbit F3 = p ^ 2; Sbit F4 = P1 ^ 3; Unsigned char code FFW [8] = {XFC 0 xfe, 0, 0 XFD, 0 xf9, 0 XFB, 0 xf3, 0 xf7, 0 xf6}; / / reverse Unsigned char code FFZ [8] = {xf3 xf6 0, 0 xf7, 0, 0 XFB, 0 xf9, 0 XFD, 0 XFC, 0 xfe}; / / is Unsigned int K; / * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * step motor drive * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / Void motor_ffw () { Unsigned char I; Unsigned int j; For (j = 0; j 50; j + +) / / 1 * n circles { For (I = 0; I 8; I + +) / / a period of 30 degrees { If (K = = 1) {P1 = FFW [I] 0 x1f; / / g