混凝土浇筑方案 及注意事项（Concrete pouring scheme and precautions）.doc

混凝土浇筑方案 及注意事项（Concrete pouring scheme and precautions） The concrete pump USES maintenance points Concrete pump truck has been used in the construction of concrete pouring, the advancement and the maintenance of the equipment technical complexity, determines the use, maintenance and management of it staff to put forward higher requirements. In order to ensure that the concrete pump can meet the required technical state, reduce the maintenance cost, improve the reliability and service life of the use, the maintenance procedures for its use must be carried out carefully. I. safe operation procedures In order to ensure the safety of the concrete pump operation and avoid causing personal or equipment accidents, the following safe operating procedures must be strictly observed. 1. Venue selection. Avoid obstacles such as high pressure lines as far as possible. 2. Check before homework. The power switch of the operating station should be in the off position; The displacement handle of the concrete displacement handle and stirring device shall be located in the middle part. 3. Leg operation. The concrete pump should be placed horizontally and the ground should be flat and solid, so that the working process will not be sunken. The legs can support the whole machine reliably and reliably. 4. Arm stand operation. When the arm frame is extended or withdrawn from folded state, it must be carried out in accordance with the specified order. The rotary operation of the arm frame must be carried out after the arm frame is completely left. The arm frame shall not be used when the storm condition or the wind has reached level 8 or above (wind speed of 16 ~ 17m/s). Arm frame must not be used for lifting. 5. Pumping operation. When the pump is started or stopped, contact the operator at the end of the hose; The bending radius of the end hose shall not be less than 1m, and no bending is allowed. Before disassembling the clogging pipe, the pump should be pumped 2 ~ 3 times before removing