蓝光故障代码（Blu ray fault code）.docVIP

蓝光故障代码（Blu ray fault code） Blue light failure code analysis Detailed failure code analysis ER2: open door interlock interrupt in elevator operation. Phenomenon 1: during the operation, the door knife and the door collided with the door lock. Phenomenon 2: if the FU16 is set to ON, the system determines whether the door lock is closed and the restriction signal of the door is concerned. If FU16 is set to ON, the closing limit is not allowed to cause ER03 protection. Phenomenon 3: motherboard detection signal using two lock detection, X4 contact input, X23 lock loop voltage detection, such as lock loop voltage is not high enough, the requirements of the standard AC110V, such as lower than AC100V, the fault voltage input instability will cause ER02. The phenomenon of 4:ER02 fault occurs on the top floor, synchronous traction machine, synchronous traction machine brake delay time is too long, easy to cause the lift onto the limit, this phenomenon, before the 02 emergency stop fault fault. (normal to the top floor parking, the system after the brake, so that the direction will remain set time, brake, off, time so that the elevator door is not closed stable, the inverter still has torque output. If the door lock is accidentally broken, the door lock contacts can turn off the frequency converter and cause the pulley limit. Phenomenon 5: frequency conversion door machine, because the switch door signal from the control cabinet direct lead from the accompanying cable to the top of the car. Such as excessive interference during operation, the door controller receives the error error caused by open command, open the ER02 fault, which, in car top mounted on the opening and closing the relay control cabinet, first at the closing signal to drive the car top door to open and close the door by relay, relay contact control gate machine controller. The method can effectively prevent the signal from opening and closing the door to interfere with the misoperation of the door. ER03: fre