第十六章 水泥混凝土路面设计（The sixteenth chapter is the design of cement concrete pavement）.doc

第十六章 水泥混凝土路面设计（The sixteenth chapter is the design of cement concrete pavement） The sixteenth chapter discusses the design of cement concrete pavement A fill in the blank. 1. cement concrete plate refers to the width of the distance between _____ or longitudinal seam between the pavement and the edge line distance, plate length refers to the distance between __________. 2. dynamic load coefficient refers to the ratio of _____ and _____ influence on pavement fatigue damage. 3. concrete pavement design strength is _____ strength of concrete as the standard, the age is _____ days. Based on the strength parameters of 4. cement concrete pavement to the top surface of the base _____ multiplied by the modulus a modulus growth coefficient, obtained _____ modulus of base top surface. 5. in order to ensure the expansion joint load transfer capacity, should be provided in the middle of _____ expansion rod, the rod is usually used _____ steel. 6. rigid pavement traffic classification is mainly based on _____ axis using the initial load on time division, the road of heavy traffic, the design life of _____ years. 7. _____ deformation of rigid pavement structure under load, concrete damage is mainly caused by _____. The 8. bars are usually located in a joint, in order to make the vehicle load stress favorable transfer, prevent the wrong station, usually in _____ seam dowels. 9. rigid pavement and other buildings are connected, usually to set the _____ gap is appropriate, the seam is mainly to prevent the crack of concrete slab due to _____ stress. 10. rigid pavement longitudinal and transverse joints between each other to _____ is appropriate, when a paving width is greater than 4.5m, adding _____ longitudinal seam. 11. cement concrete pavement design theory is _____________________ -- the current specification, the load stress calculated by _____________________ -- method. 12. cement concrete pavement under the traffic, according to _____________________ -- is divided into four l