温度塞测量.pdfVIP

F 04 N 0040 Procedure Number F 04 N 0040 Issue no 6 Issue Date October 2002 MAXIMUM COMPONENT TEMPERATURE TEST Written by : N. McComb / St. Brunner Date: OCTOBER 2002 Approved by Dr. U. Sauerwein Date : OCTOBER 2002 Key Words : Cooling System, Component Temperatures Page 1 of 17 F 04 N 0040 1 OBJECTIVE This procedure is applicable for all engine types. Certain component temperatures can be critical for durability and function. This proce- dure describes tests which should be carried out as part of a standard Mechanical De- velopment Test Program, to investigate component surface temperatures under con- trolled conditions. The Components considered here are : − Cylinder Head Combustion Chamber − Cylinder Bore − Piston − Valves (especially Exhaust) Due to the different requirements of the measuring systems or techniques it is neces- sary to carry out different procedures appropriate to the components under investiga- tion. This procedure considers only components cooled predominantly by coolant and/or oil, and not those such as exhaust manifolds where radiation and air convection (natural or forced) are dominant and thus can only be examined realistically in an “as installed” situation due to the influences of vehicle aerodynamics etc. 2 TEST PREPARATION 2.1 ENGINE SPECIFICATION The engine used for the thermal survey should have completed the specified Break-in Procedure plus typically 50 to 100hrs of running, covering the full range of load condi- tions, before instrumentation. A full load cur