CRACKING PARTS OF THE ROLLING BEARING （开裂的部分滚动轴承）.pdfVIP

th 12 International Research/Expert Conference ”Trends in the Development of Machinery and Associated Technology” TMT 2008, Istanbul, Turkey, 26-30 August, 2008 CRACKING PARTS OF THE ROLLING BEARING J. Bezecný, J. Šišáková Faculty of Industrial Technologies, I. Krasku 491/30, 020 01 Púchov, Slovakia, bezecny@fpt.tnuni.sk František Šišák PSL, a. s, Robotnícka ulica, 017 01 Považská Bystrica, Slovakia ABSTRACT Rolling bearings employ rolling elements /like balls or rollers/ interposed between two race ways, and relative motion is permitted by the rotation of these elements [1]. This experimental work deals with materials properties of the rolling bearing, where were investigated some cracks on the circular round after the induction hardening. Probably it is the case of bad – no optimal conditions of heat treatment especially surface hardening. Keywords: induction quenching, rolling bearing, intergranular fracture 1. INTRODUCTION Rolling bearings are components which make possible the relative motion of parts and the transmission of active force – characteristics – imposition of rolling parts between two relatively parts which are in motion. To advantages we can assign – low values of friction factor – its low dependency of operating conditions, good centering of shaft position, ickle consumption, easy bearing lubrication, operation ability in extremely temperature values, simply service and easily convertibility.