初中科学(物理)常见的六十九个错误点（There are sixty-nine mistakes in science (physics) in junior high school）.docVIP

初中科学(物理)常见的六十九个错误点（There are sixty-nine mistakes in science (physics) in junior high school） There are sixty-nine mistakes in science (physics) in junior high school Source: wenzhou tutor bar date: 2011-11-4 1. 1 kg indicates 9.8 N. Two different quantities can only be changed by formula. 2. The lunar spring meter and balance can be used, the balance cannot be used in the weightlessness of space and the spring meter can also measure the force other than gravity. 3. Pressure increases friction does not necessarily increase. Sliding friction is associated with stress, but the static friction force has nothing to do with stress, and it only has to do with the forces that balance it. 4. The interaction between two objects does not necessarily occur. It also depends on the conditions such as compression and relative motion. 5. The roughness of the friction and contact surface is related to the size of the contact area. 6. Lever adjustment: left high left; The sky is flat: the pointer is skewed to the left and right. The balancing nut on both sides is adjusted in the same direction. You must save half of the force on the pulley. Only if you pull in a vertical or horizontal direction, youre going to be half the force. 8. Draw lever method: find a fulcrum (at the fixed points in the leverage), 2 drawing force action line (extended the power to extend or reverse), three even distance (a fulcrum, to force the action line of perpendicular), four letters. 9. The power minimum, the arm should be the largest. Arm maximum: find a point on the lever to make this point as far as the fulcrum. 10. The force area of the pressure is the contact area, and the unit is m2. Note that the contact area is one or more, and should pay more attention to unit conversion: 1 cm2 = 10-4m2 11. The speed of uniform linear motion must be constant. The velocity must be a definite value as long as it is moving in a straight line. 12. The average speed can only be the total distance divided by the total t