网线的水晶头内8根线如何顺序如何排列（8 lines in the crystal head of a network cable, how to arrange in order）.doc

网线的水晶头内8根线如何顺序如何排列（8 lines in the crystal head of a network cable, how to arrange in order） Production of cable I. understanding of tools and materials Before making the cable, you must prepare the tools and materials. The first tool is RJ-45 tool, there are three different functions of the tool, the front is stripping mouth, it is used to peel twisted shell. The middle is to suppress the RJ-45 header slot, where RJ-45 heads can be twisted with twisted wires. The nearest end of the handle is a sharp tangent knife which can be used to cut the twisted pair here. Next, the materials needed are RJ-45 heads and twisted pairs. Since RJ-45 is crystal clear and transparent, it is also commonly known as the crystal head. Each pair of twisted wires is connected with the network card and the hub (or switch) by installing the RJ-45 crystal head. A twisted pair is a pair of four pairs of wires wrapped in an insulated outer shell twisted by two insulated wires, which are twisted to reduce interference between the transmitted signals. As the saying goes, work is good for its work, and you must sharpen your tools.. Here we would like to introduce how to make your tool very Li, so as to achieve twice the result with half the effort. RJ-45 tool as above we see, sometimes making out the unqualified cable, this is because the tool clamp of the tooth in the mouth is not aligned crystal metal sheet on the head, resulting in sheet metal and wire can not correct contact, so there is the phenomenon of network. So, in choosing the RJ-45 tool pliers, be sure to pay attention to the tool clamp down, each tooth above it can correspond to the metal on the crystal head one by one, so as to ensure the production of a qualified cable. Two, the standard of network cable and connection method: There are two international standards for double line intersection: EIA/TIA568A and EIA/TIA568B, and there are two main connection methods for double intersecting lines: straight through cable and crossed cable