海尔家居（haier home）.docVIP

海尔家居（haier home） Haier home construction process requirements I. electrical parts (I) conventional practices: 1, the household distribution box is equipped with an electric leakage short circuit device as the main switch, and is divided into a plurality of points, a control, an illumination, a socket and a large power electric equipment. 2, household appliances used for power plug socket single-phase electric connection mode, the maximum power plug: inductive load (motor) 0.25KW (resistive load, water heater, microwave oven etc.) 2KW. 3, large power electric equipment (more than 1KW) to separate circuit wiring, and select the 15A single-phase three hole socket. 4 、 bathroom outlet adopts splash proof type. 5. The wiring of the weak current system can be equipped with dark fittings and bright fittings, but shall not be installed with strong electricity pipes. The panels used shall be in the same series as switches and sockets. 6 、 the leakage switch is installed vertically. The wiring according to the product specification, press the test button to check its performance. 7. Electrical equipment should be firmly connected, good contact, reliable grounding. (two) electrical wiring: 1, electrical wiring should be buried pipe laying, take the nearest route laying. 2, threading pipes are not allowed to have joints and kinks, joints should be set in the online box, the joints should be welded, bend must bend or cold bend. 3, concrete ceiling, lintel used plastic sheath wire. 4. All wires are made of copper core. The threading tube and wire box must be flame retardant products. 4, lighting line cross-section is not less than 1.5mm2, Socket line 2.5mm2, high power socket 4mm2, total table line Over 6mm2. 5, electrical wiring and hot water pipe parallel laying distance: water pipe at the bottom should not be less than 30cm, water pipe at the top should not be less than 20cm, cross lay not less than 10cm. 7 、 FireWire is controlled by switch. 8, switch position for easy operat